Windward Software Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

{{:wws100i-hero-250.jpg?300|}}

[[https://www.windwardsoftware.com/resources/shop-pos-hardware.html|SHOP FOR COMPATIBLE HARDWARE]]
====== Programming Wasp WWS100i Bluetooth Scanner ======

<note>This step-by-step instruction assumes that the scanner driver is already installed and communicating properly with the host machine.</note>
===== 
Once you have confirmed that the device is already scanning in Windows. You can then proceed with the configuration of the CTR-B preamble. Follow the steps below... =====

  - Scan the ‘Clear Pre/Postamble’ barcode
      * Page 12 on the user’s manual (http://content.etilize.com/User-Manual/1024500496.pdf)

{{:clear.jpg|}}
  - Scan the ‘Preamble’ barcode
      * Page 12 on the user’s manual (http://content.etilize.com/User-Manual/1024500496.pdf)

{{:preamble.jpg|}}
  - Scan the ‘STX’ barcode
      * Page 26 on the user’s manual (http://content.etilize.com/User-Manual/1024500496.pdf)

{{:stx.jpg|}}


{{:wasp_wws_100i.docx|Download the configuration document}}

//Nov 09, 2015//