Differences

This shows you the differences between two versions of the page.

--- isc250_configuration [2018/11/09 11:48 (6 years ago)] – swind
+++ isc250_configuration [2018/11/13 11:30 (6 years ago)] – swind
@@ Line 4: / Line 4: @@
 [[http://wws5.com/|{{http://wws5.com/images/topxxxgif-ani.gif  |Windward Software}}]]
-====== Configuration ======
+====== SETUP / CONFIGURATION ======
 {{::isc250.jpg?200|}}
@@ Line 18: / Line 18: @@
 https://www.datacapsystems.com/support-articles/how-to-change-pin-pad-interface-settings
-once configured, Set the pin pad type to the ISC 250 and if supported by the payment processor you can set the IP Address in the setup wizard.
+Once configured, Set the pin pad type to the ISC 250 and if supported by the payment processor you can set the IP Address in the setup wizard.
 Even though you will not be using a COM port to communicate with the pin pad, the DSI Client software requires one to be selected. If you do not select one you will get an error saying "Incomplete Transaction" "COM port not found in XML". Any valid COM Port can be selected.
@@ Line 30: / Line 30: @@
-Don't use port forwarding.
+Don't use port forwarding or COM Port redirection. This is highly problematic, especially for US Payment Processors.