User Tools

Site Tools


home_equinox_pinpad_setup

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
home_equinox_pinpad_setup [2014/08/08 10:35 (10 years ago)] craighome_equinox_pinpad_setup [2015/01/06 16:03 (9 years ago)] (current) cparagoso
Line 28: Line 28:
 **DO NOT PLUG THE DEVICE TO THE COMPUTER UNTIL ALL DRIVERS ARE INSTALLED AND DEVICE IS CONFIGURED** **DO NOT PLUG THE DEVICE TO THE COMPUTER UNTIL ALL DRIVERS ARE INSTALLED AND DEVICE IS CONFIGURED**
  
-Drivers can be downloaded from here:F:\USERS\Equinox L5300\USDebit16875.zip+Drivers can be downloaded from here: ftp://ftp.windward-ca.com/pub/mercurypay/Equinox_L5000_USB_Driver.zip
  
 Installing device drivers on Computer: Installing device drivers on Computer:
  
-1. installing L5000 Serial Driver (01 - L5000 SErial Driver). +1. Unzip the downloaded program, Plug in the USB and allow the driver to update from the unzipped folder.
- a. Run Install.bat for your operating system +
- +
-2. installing FPE Interface (02 - FPE Interface)   **NO DO NOT INSTALL THIS** +
- a. Run HypercomFPEInterfaceSetup.EXE **NO DO NOT INSTALL THIS**+
  
 3. Restart Computer 3. Restart Computer
  
-4. Plug the device to the computer. If both installation were successful your device should be detected and you will see a Hypercom L5xxx Terminal(COM1) on the Device manager ports. +4. Plug the device to the computer. If both installation were successful your device should be detected and you will see a Hypercom L5xxx Terminal(COM5) on the Device manager ports.
- +
-{{:equinox.jpg?200|}} +
- +
-**Please take note : Once the device is installed corrected and plugged in, do not un-plug the device from the computer. This may assign new COM port to the device and may not function properly.**+
  
 +{{:equinox.jpg?500|}}
  
  
Line 51: Line 44:
 Hypercom L5000 driver failed to install Gaget Serial v2.4:  Hypercom L5000 driver failed to install Gaget Serial v2.4: 
  
-{{:equinoxfailed.jpg?200|}}+{{:equinoxfailed.jpg?500|}}
  
  
Line 62: Line 55:
 3. Select Brows my computer for driver software 3. Select Brows my computer for driver software
  
-{{:failedriver.jpg?200|}}+{{:failedriver.jpg?500|}}
  
 4. Select Browse under Search for driver software in this location and point to  the location where the 01-L5000 Serial Driver for your operating system is location and click next. 4. Select Browse under Search for driver software in this location and point to  the location where the 01-L5000 Serial Driver for your operating system is location and click next.
home_equinox_pinpad_setup.txt · Last modified: 2015/01/06 16:03 (9 years ago) by cparagoso