Differences

This shows you the differences between two versions of the page.

--- home_equinox_pinpad_setup [2014/08/08 10:35 (10 years ago)] – craig
+++ home_equinox_pinpad_setup [2014/08/08 10:40 (10 years ago)] – craig
@@ Line 28: / Line 28: @@
 **DO NOT PLUG THE DEVICE TO THE COMPUTER UNTIL ALL DRIVERS ARE INSTALLED AND DEVICE IS CONFIGURED**
-Drivers can be downloaded from here:F:\USERS\Equinox L5300\USDebit16875.zip
+Drivers can be downloaded from here: ftp://ftp.windward-ca.com/pub/mercurypay/Equinox_L5000_USB_Driver.zip
 Installing device drivers on Computer:
-. installing L5000 Serial Driver (01 - L5000 SErial Driver).
+. Unzip the downloaded program, Plug in the USB and allow the driver to update from the unzipped folder.
- a. Run Install.bat for your operating system
-. installing FPE Interface (02 - FPE Interface)   **NO DO NOT INSTALL THIS**
- a. Run HypercomFPEInterfaceSetup.EXE **NO DO NOT INSTALL THIS**
 . Restart Computer
-. Plug the device to the computer. If both installation were successful your device should be detected and you will see a Hypercom L5xxx Terminal(COM1) on the Device manager ports.
+. Plug the device to the computer. If both installation were successful your device should be detected and you will see a Hypercom L5xxx Terminal(COM5) on the Device manager ports.
 {{:equinox.jpg?200|}}
-**Please take note : Once the device is installed corrected and plugged in, do not un-plug the device from the computer. This may assign new COM port to the device and may not function properly.**