garden_center_loop_tree_tags
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
garden_center_loop_tree_tags [2016/10/25 16:58 (8 years ago)] – swind | garden_center_loop_tree_tags [2016/10/31 09:51 (8 years ago)] – swind | ||
---|---|---|---|
Line 17: | Line 17: | ||
These labels come in several sizes. The most common being 7 inch long by 1 inch wide, or 10 inch long by 1inch wide. | These labels come in several sizes. The most common being 7 inch long by 1 inch wide, or 10 inch long by 1inch wide. | ||
- | | {{: | + | | {{: |
- | In the case of the tags with the holes on the top or bottom, they usually come in a 4 across or 5 across configuration. | + | In the case of the tags with the holes on the top or bottom, they usually come in a 4 across or 5 across configuration. |
- | In most cases these labels are 1 inch wide regardless of their orientation. However, if you need loop tags that are wider than 1 inch, you would be limited to a 3 across or 4 across depending on the width of your thermal print head. | + | Also, In most cases these labels are 1 inch wide regardless of their orientation. However, if you need loop tags that are wider than 1 inch, you would be limited to a 3 across or 4 across depending on the width of your thermal print head. |
garden_center_loop_tree_tags.txt · Last modified: 2021/05/11 16:21 (3 years ago) by jbalasabas