faq:zebra_or_eltron_labels_skipping
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
faq:zebra_or_eltron_labels_skipping [2008/10/09 15:11 (16 years ago)] – Added manual method to sense the gaps. cliff | faq:zebra_or_eltron_labels_skipping [2008/12/03 11:56 (16 years ago)] (current) – andrew | ||
---|---|---|---|
Line 5: | Line 5: | ||
{{faq: | {{faq: | ||
+ | |||
===== Additional method to manually force the printer to sense the gap ===== | ===== Additional method to manually force the printer to sense the gap ===== | ||
- | There is a way to have the Zebra TLP2844 | + | |
+ | These procedures are to be run when the Zebra printer | ||
+ | |||
+ | Use only the labels provided by [[http:// | ||
+ | |||
+ | Turn off the printer | ||
+ | |||
+ | There is a big distinction between the Zebra printer and Z Designer. Make sure you're using the correct driver and printer. | ||
+ | |||
+ | |||
faq/zebra_or_eltron_labels_skipping.txt · Last modified: 2008/12/03 11:56 (16 years ago) by andrew