Only the configurations below will work.
Tested scanners and settings
You MUST set the scanner to HID mode for it to work.
On an LCD Monitor you may be able to scan off the screen. Otherwise Print the PDF and scan the barcodes off the printed copy.
In the POS Device Manager, click on the Scanner Tab, and put a check mark in the checkbox next to Keyboard Wedge Scanner. Leave the Port Setting set to None.
Then click on the HID tab and set Scanner 1 to 4600
Must be set to USB Virtual COM port emulation mode to work.
On an LCD Monitor you may be able to scan the following barcodes off the screen. Otherwise download and open the EVO_Omni_Configuration_Guide.pdf, print page 31 of the Configuration Guide and scan the USB Virtual COM Port Emulation barcode.
If Windows doesn't automatically install a driver for the scanner it will prompt you to install a driver.
If this is the case, Install one of the drivers below for USB-Serial emulation.
Serial Driver Windows 8, 64 Bit
Serial Driver Windows 7, 64 Bit
Serial Driver Windows 7, 32 Bit
Next, open Windows Device Manager, and look for the new com port. It should be the one called Motorola CDC USB Device. Make a note of the COM port number.
Next, open the Windward POS-Device Manager.
On the Barcode Scanner Tab, select the same com port that you noted from the Windows Device Manager, This was COM6 in our example.
Must be set to USB - COM mode to work, (COM port Emulation). To do this just scan the barcode on the right
Then the COM Port number displayed in the Windows Device Manager must be selected in the POS Device Manager.
Created by Steve Wind January 26 2017