datalogic_quickscan_2d
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
datalogic_quickscan_2d [2016/08/26 11:18 (8 years ago)] – swind | datalogic_quickscan_2d [2018/09/07 09:30 (6 years ago)] – swind | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Datalogic QuickScan (2D Models) ====== | + | {{ : |
Line 12: | Line 12: | ||
====== Programming The Datalogic QuickScan 2D Barcode Scanner ====== | ====== Programming The Datalogic QuickScan 2D Barcode Scanner ====== | ||
+ | ===== This setup would be the same for System Five on Cloud configuration.===== | ||
===== Models : Datalogic QuickScan QD24XX – QBT24XX – QM24XX ===== | ===== Models : Datalogic QuickScan QD24XX – QBT24XX – QM24XX ===== | ||
Line 23: | Line 24: | ||
First tone is a double beep, then a warble tone, and then an Ascending tone. | First tone is a double beep, then a warble tone, and then an Ascending tone. | ||
- | If barcode scanner still is not performing correctly, scan the "Reset To Factory Defaults" | + | If barcode scanner still is not performing correctly, scan the "Reset To Factory Defaults" |
First tone is a double beep, then a warble tone, and then an Ascending tone. | First tone is a double beep, then a warble tone, and then an Ascending tone. | ||
Line 36: | Line 37: | ||
{{: | {{: | ||
- | Manual can be downloaded from http:// | + | Manual can be downloaded from |
+ | |||
+ | {{ :barcodescan: | ||
Installed the USB to Serial driver | Installed the USB to Serial driver | ||
- | http:// | + | |
+ | {{ :barcodescan: | ||
Windows automatically picked up the scanner and installed the drivers. | Windows automatically picked up the scanner and installed the drivers. | ||
Line 54: | Line 59: | ||
Now you will need to open the POS Device Manager as administrator and set the port to the one in the Windows Device Manager (Shown in picture above). | Now you will need to open the POS Device Manager as administrator and set the port to the one in the Windows Device Manager (Shown in picture above). | ||
+ | You may need to check the Keyboard Wedge checkbox as well. | ||
Once this is done, no other configurations are necessary. | Once this is done, no other configurations are necessary. | ||
In this configuration, | In this configuration, | ||
+ | |||
+ | |||
+ | |||
+ | |||
+ | ====== Removing Leading And Trailing Digits From UPC Barcodes ====== | ||
+ | |||
+ | <note important> | ||
+ | Be aware that if you do this, it will do it for all barcodes going forward, and all barcodes scanned previously with the first and last digits attached will not scan anymore. | ||
+ | So you MUST be absolutely sure that you need to do this. </ | ||
+ | |||
+ | Print the following document and scan the highlighted 2D barcodes in the numerical order specified. | ||
+ | |||
+ | {{ : | ||
datalogic_quickscan_2d.txt · Last modified: 2021/12/06 15:57 (2 years ago) by swind