Differences

This shows you the differences between two versions of the page.

--- cloud_label_size_not_remembered [2019/06/04 16:30 (5 years ago)] – swind
+++ cloud_label_size_not_remembered [2019/11/21 11:26 (4 years ago)] – swind
@@ Line 26: / Line 26: @@
   * Wait approximately 2 minutes, and then log back into your cloud environment.
   * Verify that the setting has been replicated to the driver in your Cloud session
+\\
+\\
+\\
+===== Additional Notes =====
+==== Label Stocks ====
+You may also find it beneficial to set up a label stock rather than using the default label size. Even if you always use the same size label, most label printers seem to work more reliably when this is done.
+Open Devices and Printers.\\
+Right click on the label printer and select Printer Properties.\\
+Click on the Stocks tab.\\
+click the New button.\\
+\\
+{{:labelprinter:zebra:label_stocks.jpg?700|}}\\
+\\
+Setup your label Dimensions. Most Important is the Width and Hight, and give it a name that makes sense.\\
+Click OK.\\
+Now click on the General Tab and the Preferences button.\\
+\\
+{{:labelprinter:zebra:label_stocks2.jpg?700|}}\\
+\\
+On the Options Tab under Settings, set your Stocks to the one you just created.\\
+Click the Apply button, then click the OK button. \\
+Click OK button to exit the printer properties.\\
+==== Setting the Label Printer as the Default Printer ====
+This may be necessary for some label Printer Drivers.\\
+\\
+Open Devices and Printers.\\
+Right click on the label printer and select Set as Default Printer.\\
+\\
+{{:labelprinter:zebra:set_as_default_printer.jpg?250|}}\\
+\\
+\\
@@ Line 32: / Line 71: @@
 == Steve Wind April 26 2019 ==
+== Updated November 21 2019 ==