cloud_label_size_not_remembered
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
cloud_label_size_not_remembered [2019/05/08 16:02 (5 years ago)] – swind | cloud_label_size_not_remembered [2019/11/21 11:26 (4 years ago)] – swind | ||
---|---|---|---|
Line 7: | Line 7: | ||
This is for Zebra Label printers. | This is for Zebra Label printers. | ||
- | Specific models would be the TLP 2824, TLP 2844, LP 2824, LP 2844, and GK 420T. | + | Specific models would be the TLP 2824, TLP 2844, LP 2824, LP 2844, GC 420T and GK 420T. |
Label size is set in the local workstation but when we open the driver in the System Five on Cloud environment, | Label size is set in the local workstation but when we open the driver in the System Five on Cloud environment, | ||
Line 26: | Line 26: | ||
* Wait approximately 2 minutes, and then log back into your cloud environment. | * Wait approximately 2 minutes, and then log back into your cloud environment. | ||
* Verify that the setting has been replicated to the driver in your Cloud session | * Verify that the setting has been replicated to the driver in your Cloud session | ||
+ | |||
+ | \\ | ||
+ | \\ | ||
+ | \\ | ||
+ | |||
+ | ===== Additional Notes ===== | ||
+ | |||
+ | ==== Label Stocks ==== | ||
+ | You may also find it beneficial to set up a label stock rather than using the default label size. Even if you always use the same size label, most label printers seem to work more reliably when this is done. | ||
+ | |||
+ | Open Devices and Printers.\\ | ||
+ | Right click on the label printer and select Printer Properties.\\ | ||
+ | Click on the Stocks tab.\\ | ||
+ | click the New button.\\ | ||
+ | \\ | ||
+ | {{: | ||
+ | \\ | ||
+ | Setup your label Dimensions. Most Important is the Width and Hight, and give it a name that makes sense.\\ | ||
+ | Click OK.\\ | ||
+ | Now click on the General Tab and the Preferences button.\\ | ||
+ | \\ | ||
+ | {{: | ||
+ | \\ | ||
+ | On the Options Tab under Settings, set your Stocks to the one you just created.\\ | ||
+ | Click the Apply button, then click the OK button. \\ | ||
+ | Click OK button to exit the printer properties.\\ | ||
+ | |||
+ | |||
+ | ==== Setting the Label Printer as the Default Printer ==== | ||
+ | |||
+ | This may be necessary for some label Printer Drivers.\\ | ||
+ | \\ | ||
+ | Open Devices and Printers.\\ | ||
+ | Right click on the label printer and select Set as Default Printer.\\ | ||
+ | \\ | ||
+ | {{: | ||
+ | \\ | ||
+ | \\ | ||
+ | |||
Line 32: | Line 71: | ||
== Steve Wind April 26 2019 == | == Steve Wind April 26 2019 == | ||
+ | == Updated November 21 2019 == | ||
cloud_label_size_not_remembered.txt · Last modified: 2021/05/11 20:10 (3 years ago) by jbalasabas